Software Updates
@rugedraw Yes, the dealer here in UAE did it for me after multiple escalations to their management. Is 22293 available on my VIN and is that the most recent update? They claimed 22192 is the latest one but I got little to no faith in them.
Can you check mine 1FTFW1ED0PFB10936
VIN: 1FTFW1ED5PFA883 97
This week the truck seems to have tried to download 6.8 but so far without success. Sometimes says it failed. Other times it just doesn't happen, even though the "scheduled time" goes by.
This week the truck seems to have tried to download 6.8 but so far without success. Sometimes says it failed. Other times it just doesn't happen, even though the "scheduled time" goes by.
I don't have access to FDRS until later to check for pending module updates since I don't bring my laptop to work. However, if they did update the APIM and did not see another one, it is because updates have to be installed in a certain order before more updates will show up for a vehicle. They would have had to update the GWM and/or the TCU to get the next APIM update to show up. Ford does not pay dealers to perform module updates even under warranty. Nobody likes to work for free, so dealers will always be reluctant to help when it comes to these things.
"groupId":"1""totalLvBatteryCapacity":"58""current LvBatterySoc":"35""availableLvBatteryCapacity":"20 300"
Capacity is not terrible at 58 of 70, but SoC is very low. I recommend you fully charge the battery and try again. If that does not work, fully charge it and reset the BMS and then try again.
Remind me after 8pm eastern. I will most likely forget.
Hi rugedraw,
My VIN is 1FTFW1ED0NFA40125. I'm in the Power-Up EAP and was receiving OTAs timely, but my last update was Nov 22nd for the revised 6.2.0 (23-PU1103-NAT-VCE). I've seen a few phantom updates since then (shows that an update is pending, but no messages after the scheduled update time saying that an update installed or failed). I'm guessing that I'm just at Ford's mercy for the next 6.x.x updates, but I wanted to check if there were any issues that you could see.
Thank you for all of your help here an in places!
My VIN is 1FTFW1ED0NFA40125. I'm in the Power-Up EAP and was receiving OTAs timely, but my last update was Nov 22nd for the revised 6.2.0 (23-PU1103-NAT-VCE). I've seen a few phantom updates since then (shows that an update is pending, but no messages after the scheduled update time saying that an update installed or failed). I'm guessing that I'm just at Ford's mercy for the next 6.x.x updates, but I wanted to check if there were any issues that you could see.
Thank you for all of your help here an in places!
Hi rugedraw,
My VIN is 1FTFW1ED0NFA40125. I'm in the Power-Up EAP and was receiving OTAs timely, but my last update was Nov 22nd for the revised 6.2.0 (23-PU1103-NAT-VCE). I've seen a few phantom updates since then (shows that an update is pending, but no messages after the scheduled update time saying that an update installed or failed). I'm guessing that I'm just at Ford's mercy for the next 6.x.x updates, but I wanted to check if there were any issues that you could see.
Thank you for all of your help here an in places!
My VIN is 1FTFW1ED0NFA40125. I'm in the Power-Up EAP and was receiving OTAs timely, but my last update was Nov 22nd for the revised 6.2.0 (23-PU1103-NAT-VCE). I've seen a few phantom updates since then (shows that an update is pending, but no messages after the scheduled update time saying that an update installed or failed). I'm guessing that I'm just at Ford's mercy for the next 6.x.x updates, but I wanted to check if there were any issues that you could see.
Thank you for all of your help here an in places!
Rugedraw, it's been a while (October?) that my APIM was installed and updated. Since then not a single update. I notice someone else has posted with the same report. Would you mind taking another look at mine?
Do I need to just break down and go the Mongoose route?
VIN 1FTFW1EDXMFB53269
Thank you -Rex B
Do I need to just break down and go the Mongoose route?
VIN 1FTFW1EDXMFB53269
Thank you -Rex B
Rugedraw, it's been a while (October?) that my APIM was installed and updated. Since then not a single update. I notice someone else has posted with the same report. Would you mind taking another look at mine?
Do I need to just break down and go the Mongoose route?
VIN 1FTFW1EDXMFB53269
Thank you -Rex B
Do I need to just break down and go the Mongoose route?
VIN 1FTFW1EDXMFB53269
Thank you -Rex B
https://www.f150gen14.com/forum/thre...-thread.13145/








