When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
There was a GWM software update that appeared this morning in FDRS and after I completed it in my truck then an APIM update appeared and I did that also so now I have:
Question for you the expert, after receiving 2.8.1 I have a collision fault warning, an APIM trouble code and have no cruise, lane keep / centering at all. In your valued opinion do you think these updates could possibly correct any of this? I haven’t had time to give the truck up to a dealer yet.
There was a GWM software update that appeared this morning in FDRS and after I completed it an APIM update then appeared in FDRS and I did that also so now I have:
Question for you the expert, after receiving 2.8.1 I have a collision fault warning, an APIM trouble code and have no cruise, lane keep / centering at all. In your valued opinion do you think these updates could possibly correct any of this? I haven’t had time to give the truck up to a dealer yet.
Did you make any changes in IPMA with FORScan before the OTA update? If so, try reverting those changes, try clearing the DTCs below and let me know what remains? If they all clear then you can try enabling the cams in motion (presuming that's the changes you had made if any) to the IPMA
Did you make any changes in IPMA with FORScan before the OTA update? If so, try reverting those changes, try clearing the DTCs below and let me know what remains? If they all clear then you can try enabling the cams in motion (presuming that's the changes you had made if any) to the IPMA
Ok thanks. Yea there has been some IPMA changes made to the IPMA, wasn’t enabling cameras in motion but I know I changed something. My truck also wouldn’t update so had the IPMA reprogrammed by the dealer prior to the OTA. I’ll set stuff back to stock and try clearing codes and see what happens. I’ll keep you updated. Thanks for your help. Could you please either post your donation link or message it me please.
Did you make any changes in IPMA with FORScan before the OTA update? If so, try reverting those changes, try clearing the DTCs below and let me know what remains? If they all clear then you can try enabling the cams in motion (presuming that's the changes you had made if any) to the IPMA
Wait, I made some changes to the APIM but don’t think the IPMA. Gone for the weekend, have to check when I get home tomorrow evening but I’m pretty confident I haven’t made any IPMA changes but will check.
Wait, I made some changes to the APIM but don’t think the IPMA. Gone for the weekend, have to check when I get home tomorrow evening but I’m pretty confident I haven’t made any IPMA changes but will check.
Yeah, just revert any changes you think you did to apim or ipma, clear the codes and see if Cruise is working again. If so, then you can try to put those changes back 1 by 1 and verify Cruise is working after each change and if not then you should be able to spot the culprit change that caused it.
Think I discovered a new requirement with the latest OTA update.
Use to be you could allow the truck, when using adaptive cruise, to slow down to zero. When traffic started moving, so did the truck.
Now you have to press resume before it moves off again. I'm ok with this. Just a small thing, but proves you are paying attention.
My truck has done that since it was new in July 2021. Just depends how long it was stopped, more that about 10 seconds and you have to hit the resume button.
