Bummer, that can't be it...? If so, it kind of stunk...short.

Try not to watch it now

 

Yep...didn't take you seriously enough the first time lol.

 

3D printed 90's, -

https://www.f150forum.com/f6/shredde...2/#post6815683

Could of really used those at one time. Would of ordered at least dozen if I could find them back then. They are wire savers.

 

I had forgotten about that thread.... thanks for bringing it back into memory. Last night I printed a drill bit sharpener attachment for a Dremel. I just need to go over to Cal Ranch and get the right size nut and bolt for it now.

 

Looking at the pics of that 03 at auction in Slidell LA. https://www.f150forum.com/f6/03-f150...mmings-540225/
Nice looking outside, interior is great,
The you get to the undercarriage, Oh geeze, This ain't typical down south truck. That thing been in flood?

Look at the experain report. OOHH, New Hampshire and NewYork. Well that explains that.

 

Here's about 97.3% of the Youtube vs GOS derby

 

Looks like a flood vehicle the way the engine compartment is rusted. Fooled me at first, thought it was going to be one of those 30,000 mile vehicles.Almost looks new.

 

Yeah, I was really thinking for a minute on that one. I didn't scroll down far enough for the "real" pics.

EDIT: It says... "this 2003 Ford F150 XLT 4x4 Pickup has reportedly undergone refurbishment"

I'd hate to see what it looked like before.

 

Mentioned it's already went through body restoration, bottom of the doors and such. It's been wet, can tell by the way the firewall looks. It's rusty at the top where they don't normally rust.

EDIT: Didn't see your post above yet. But yea, the undercarriage looks worse than the 98, would have to question the frame on that one. Bet it had the rockers replaced at least once. They go before the doors do.

 

A guy at work recently wrecked/totaled his Gen 10 F150. He had some spare things for it that he asked me if I was interested in. Yep... I am always interested, LOL.