Anybody know the exact combination to make the green on the edge evolution match the stock interior green?

 

I just eyeball it.

 

Quick question, after I set all of my setting it runs thru the programming and it is complete. Now when I go back in to setup all my setting are different, and I have to redo them to the setting I want, is this normal? Should it remember my setting? I did update the programmer. Thanks

 

BillG, that is not normal, was the software update successful? I had the issue that once in while it would keep the exact tire size I had to enter, but that was it. I retained all my other settings. A few others that know more than me will chime in....Oh MGD , where are you man???

 

Thank You, Summers22, this is 6 months old and I purchased it from someone. Want to make sure it works fine. Is there a way I can see my settings without going into power programing, there is where I go in and everything is changed. Thank You again

 

You'll have to go to power programming and click "Use Previous Settings" that's not what it says but I can't recall of the top of my head. Its at the very top though. Then you can click through everything and see what it is set at. Then just keep hitting menu to back out instead of clicking "Done" to rewrite the tune.

 

^^He is 100% correct, load previous settings and adjust from there....

 

Can these settings be used/tried in EDGE CTS, coz I have a grind feel only on Lvl II (Slightly on Lvl III)at the gas pedal.

 

who can write me an amazing towing tune for my 2006 screw 4.6 4x4 3.73 gear ring for a 3000 pound car trailer and thousand pound car before tomorrow go

 

^^Just use the level 2 setting that comes pre-loaded.