im guess they should be 1'' taller than your factory blocks because stacking them is a no no

 

Can anyone tell me if I buy raptor wheels and tires take off and put them on this setup if I will get minimal to no rubbing. If anyone has photos that will also help.

 

2017, 2"+/-, rubbed on mudflaps, just removed them.

 

She looks great, John! Did you tint the taillights?

 

Thank you, yes the tails were tinted with some light grey vinyl. Can't recall where the film came from, it may have ViVid. Those tails were some cheaper aftermarket ones, DNA Motoring I think. When I sold that truck, I took them off and stuck them on the 2020. Had to do a bit of adapting the harness for an '18+.

 

2 " Zone level. 295/70/18 Falken ATW on raptor replicas +35

 

Picked up this truck a couple weeks ago. After spending some time staring at it I'm thinking its leveled. Can someone please confirm? Pretty sure what I see at the top of the strut tower is a spacer.

Measures 38.5" to the front fender and 40.25" to the rear.

 

Yup, there's a puck in there, not necessarily completely levelled, but it's not stock.

 

Looks like puck and block kit

 

Hey team, quick question. I had thought that a shackle replacement in the rear could only be used to lower the rear to level with the stock front height, not raise it. But these guys seem to have done it and the product looks nice too. Have any of yall used this to boost the rear an inch, as opposed to blocks, and are there any drawbacks? This looks like a shorter arm, so would it limit suspension travel? Thanks.

https://www.americantrucks.com/max-t...-1518-2wd.html