When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Aha! Windows are now going up. I guess I wasn't pressing double lock correctly before.
I meant the gears showing up on the 8" productivity screen. This is accomplished today by pressing gear up on the shifter but goes away once the car is turned off and on again.
You must be pushing the + - button by mistake while shifting,, or like me while resting right hand on shifter while driving with left hand.. I only do this a few times per trip...
I spent all of this past weekend trying to get a "factory" front parking aid working on our trucks. I bought 4 sensors, 4 terminals for a BCM connector, and wired it all up. I then changed settings in the PAM module to tell it the truck now had front parking aid and 10 sensors instead of 6. I was hoping to be able to report good news today but my window of opportunity ran out and I had to disconnect everything this morning cause as you can see from the pics below, I installed everything loosely and had sensors taped to bumper. I was hoping to get audible chimes working at the very least and also wanted enhanced ability for Active Park Assist (Park Out & better Perpendicular Park).
I kept the wire harness I made intact so if any new info comes my way I may revisit this in the future.
Fingers crossed that you can get this working. Let me know if I can help.
Do you have any sort of write-up on this or pictures? Curious about what you did.
No write up or pictures, all I did was take the dozen or so screws out and pull the back off the bezel. Then remove the screws from the electronic board that is over the switches. Also two connectors to disconnect and then swap the boards. The plastic buttons just pop out, so I swapped those out.
It was nice to have the extra bezel to find out how things came apart.
If you have covered blank openings where a switch is supposed to be, the electronic board underneath doesn't have any connections there, so they have different boards for the different option packages.
When I swapped Bezels, I got a few DTC's, so I tried putting my VIN in and my AB, but things still didn't quite work correctly, I kept getting a message for the left temperature sensor was missing or something to that effect.
I'd have to take it apart again to take photos, although I could use the extra one I have now.
01-30-2017, 08:56 PM
