FORScan - software to enable/disable features in your truck
08-21-2019, 05:34 PM
Senior Member
08-21-2019, 06:44 PM
Senior Member
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
08-21-2019, 06:49 PM
Senior Member
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
I just saw your other post re: Steering angle sensor, did you replace the steering rack?
Last edited by Wicked ace; 08-21-2019 at 06:56 PM.
08-21-2019, 08:50 PM
Senior Member
I did the new 2.3.24 version update and played around with it tonight, I see there’s a lot more in the plain text area menus (non as-built) so you don’t have to change the as-built numbers for the changes.
08-22-2019, 11:14 AM
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
08-22-2019, 05:42 PM
The FORScan Guy
Thread Starter
How many modules are you seeing? If you're only seeing APIM, BdyCM, and a few others then the issue is that you're not seeing all the modules on the MS-CAN which may be because of your adapter. Are you using one of the recommended adapters from the tutorial or something else?
08-22-2019, 06:44 PM
How many modules are you seeing? If you're only seeing APIM, BdyCM, and a few others then the issue is that you're not seeing all the modules on the MS-CAN which may be because of your adapter. Are you using one of the recommended adapters from the tutorial or something else?
Didnt see your entire post. I was using the adapter below. Seen quite a few recommend on the forum.
