FORScan - software to enable/disable features in your truck
Senior Member
Senior Member
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
Senior Member
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
I just saw your other post re: Steering angle sensor, did you replace the steering rack?
Last edited by Wicked ace; 08-21-2019 at 06:56 PM.
Senior Member
I did the new 2.3.24 version update and played around with it tonight, I see there’s a lot more in the plain text area menus (non as-built) so you don’t have to change the as-built numbers for the changes.
I have looked everywhere and follow your advice regarding saving files and writing as built to restore. One thing I am not clear on is PSCM initializing the steering angle sensor in the EPAS. I put in a brand new EPAS and wrote the asbuilt info from my vin asbuilt file. All the codes are gone but one. The steering angle sensor reads zero. I have the wheels straight, do I reset the pscm to get things to initialize?? Everything else works fine. What is the secret to initializing this sensor?
The FORScan Guy
Thread Starter
How many modules are you seeing? If you're only seeing APIM, BdyCM, and a few others then the issue is that you're not seeing all the modules on the MS-CAN which may be because of your adapter. Are you using one of the recommended adapters from the tutorial or something else?
How many modules are you seeing? If you're only seeing APIM, BdyCM, and a few others then the issue is that you're not seeing all the modules on the MS-CAN which may be because of your adapter. Are you using one of the recommended adapters from the tutorial or something else?
Didnt see your entire post. I was using the adapter below. Seen quite a few recommend on the forum.