no it's a 5.4. I'm thinking it won't be bad because of the e150 5.4 has what I would need. I remember an expy guy with an 04 doing the swap.

 

yes. That's where I got all mine. They printed out 5 pages for me.

 

I think so but actually a harness and pcm from a 4.6 04/05 would probably be a better option as it is 2v but is also CANBUS

 

Same as the F150

http://www.expeditionforum.com/f39/l...write-up-8875/

 

Anything and everything

Did you go to the one in Morton?
I'm going to buy a new heater pipe from Ford today ($40) so maybe they'll do about $0.60 worth of printing for me. I also need a blower bolt; one of Brett's was bent slightly

 

Getting pretty good. Still suck with think aluminum though.

 

nice progress

 

Is that from the shop you were telling me about yesterday?

If that's your welding you should change careers...damn

 

Yeah I was buying bolts too and asked them to print off pages so I could see what else I needed.

 

Yeah man. Have 5 millers here. But only two tigs. That was with a syncrowave water cooled tig.