:: hope they can rectify it for you. Sounds like one expensive mistake.

 

Thanks for pm'ing the #.

Hope they can rectify your flex plate issue.

BTW, your msg's are full again
:delete delete delete delete:

 

[MENTION=76903]fordmotorsport[/MENTION] [MENTION=52877]4x4dave[/MENTION] [MENTION=141720]Z7What[/MENTION] [MENTION=64669]jferg92[/MENTION]

Will I need a new pcv hose assy for the swap? I have the single non heated hose on it now. Any changes to the heater hoses, etc??

 

Just delete it lol

 

OK. Get a nipple & hose to use with the oil separator?

 

X2 I used the factory lightning and spliced in my metco separator but my 99 didn't have you and jfergs heated setup.

 

Just cap off the barb on the heater hose to eliminate the heated pcv hose. Then use a 1/4 npt plug off the return.

 

It's in the valley where the metal hose runs to the water pump

 

I don't have the heated setup like Jfergs. Mine is just a single hose. I'll do like Todd and run the factory L hose & splice an separator in. Don't even have my charger in hand yet but trying to make a mental list of items I'll need and mods as well. Thanks for the replies guys.

 

Cake job then.