justin51986

Has anyone used a factory raptor console switch panel in a regular f150? Just curious as to of it would fit...

justin51986

Nobody???

ttown2009KR

No ideas. It looks like it might. I thought about getting a switch panel from a f250 and installing in the console.

dlh4x4

My 2010 FX4. I installed the switch panel and console wire harness. Custom wiring and a custom mounting plate are required to mount to console. The opening in the console is slightly larger than the switch panel. This is the same on the Raptor, it's OEM console has a mounting plate in it as well. The Raptor console trim comes with the plate and is expensive for just a thin piece of plastic you can make yourself. Raptor switch panel #AL3Z-13K724-AB came complete with all the switches. Harness #AL3Z-14A318-SA comes with the entire console harness and factory connectors for the switches.

foxracer2759

iTrader: (1)

yes it will fit but i believe you need to make a plate for them to sit on the switch plate wont just snap into the spot
part #
Offroad switch - # 14B166B
Hill Decent switch - # 14B166A
4AUX switches - # 13D730 (SW-6760) Pretty sure this comes with the trim needed for all the switches.

never mind DLH beat me to it lol

pfbz

Looked up the fordsupercenter prices, posting them just for reference... Do these prices look right?

dlh4x4

I don't think you will need the last switch you have selected. The switch assembly I bought had all the switches mounted in the trim plate. The prices are about what I paid. I also purchased WPT-1076. It plugs into the console harness. Then ran custom wires for the fuse/relay box. The fuse box I used is listed at the bottom of this link. http://wagongear.com/WiredWagon.html

sharper4

How many switches are you trying to hook up? If you're just trying to put one or two in then you might consider using the existing tray in the console.

Navistarprogrammer

What are you running off of the switches? Just lights? Becarefull you don't need to run an input into the body controller to get the lights to turn on with the joining lights

rscrub

How much room is there where you mounted that switch? How difficult is it to remove the console to get there?