Check throttle stop set screw/ make sure the butterfly in air intake isn't being held open.

 

Well well decided to run truck today so I can check codes after because I had barely changed battery before. This time I got a sleugh of codes. I got
111
126
128
334
634
Wow and 123 didn't even come up. Can anyone help me out on these codes.

 

Well I guess I can disregard codes
126
128
334
I was messing with this components before checking codes.

 

Disconnected battery for 30 minutes, drove truck then checked codes koeo and got only 2 codes 111 and 634.
Can I get more code with koer?
Can any one tell me what those codes are?

 

111 means you passed the KOEO. 634 is a Continuos memory code for one of two things:
1. Manual Lever Position sensor voltage higher or lower than expected.
OR
2. A/C on during scan

Go to key on/ engine running scan. Make sure engine is pre-warmed to norm op temp first..If you pass that, we concentrate on things that can screw up that don't trigger codes.

 

Ok here are some codes I got koeo
116
536
538
632
Any ideas what they mean?

 

All of those are most likely because you didn't do the test correctly.

 

STOP.

You need to listen to what people are telling you and read through it until you understand what's being said.

There are three different code sets. KOEO and Continuous (stored) codes are run with the engine off. KOEO codes are output first, and repeated. A single flash comes next, then the stored codes are displayed and repeated. You've consistently given us unclear information on what you're getting, as you're clearly confusing the two sets. We -only- want KOEO codes, not continuous. If you're getting a '111' pass code on KOEO, move onto KOER and forget the stored codes.

Does that make any sense to you?

 

Sorry the about that. The codes
116
536
538
632
Were koer

 

So what happened to the 111 you told us that you got earlier?