I'll show yuh where to cut that piece if you want to do it. Well, I'll take a pick of it anyway, - by itself so it will be clear, and since I'll be out in the shop today.

The 3" tube to MAF cylinder is the best way to have these set up.

 

If you could do that would be great!im getting ready to go pull it apart and mock some stuff up.

 

In the middle of building my K&N /gotts mod hybrid intake that jbrew posted. I plan to put in the aFE filter that carcrazy posted will keep you guys updated.

 

That's right, okay , I'll go take it apart and snap a pic.

 

Here yuh go, from fully assembled to broken down. Yea you can see how I cut it, - just sliced off the end of the first housing piece, -









Yea , the last pic is the piece to be cut. This has work perfectly for the last 7 years or so. Nothing gets dirty inside and no leaks.

 

Well...where's your pics?

 

Thanks for the pics! Followed to a tee. Right now I have just the paper filter in ill take a pic I. The morning!

 

Great! Yea, I like pics, - unfortunately my imagination doesn't quite cut it.

 

I can see you have been taking it easy lately. Shops wayyy to clean for someone doing work. Hana.

 

You noticed! ROFL.

Yea I just cleaned up. I had a couple sheets of 3/4 board laying around, didn't know what to do with them, so I made more work space behind the cab. Blocked the frame to level it out , screwed the sheets together, - figured I might as well trim them out since I had that laying around as well lol. Nice little work bench.

I'm going to start welding on her again the 16th. By then I figure I'll get sick of the shop looking clean. I swear it only takes about 10 minutes, -before I can't find anything.