Obx long tubes. Should be installed by next week I wish sooner

 

nice! what brand are they? are you going double exhaust? How much did you pay for them?

 

Gives you time to pray that the studs come out of the heads! Hopefully the flange gaskets near the cats last. Always was a weak point. New Egr tube or delete? Look sweet! GLWI

 

Obx. Idk yet what exhaust yet

 

No cats back in! Has resonators and probably to a weld muffler

 

are they for a 4.6?? how much were they and where did you get them?

 

Ya will fit 4.6. 510$ from sparktecmotorsports.com

 

Check out HVS by Heartthrob exhaust. Made in house at their MN facility. Sound is superb, especially the shorter bodied!

 

I might just do a flowmaster out before rear tire

 

I added these to my rig this summer, and they sound cool with my single piped Borla XR-1. I did the install and it wasn't too bad, just time consuming. And I probably got lucky with the factory studs. Only one was broken off for some time, all the rest came right out when I double-nutted them. The broken one came right out with a set of Vise-Grips. I used a Stage 8 set of Locking Fastners to replace the stock set up, and checked the torque after running them up to temp a few times. Never had an issue. Did the Gotts O2 mod with the rear O2 sensors, and that works good.You will need extensions for the front O2 sensors, or you can solder the added length in, if your handy like me. Used my shop vac set to "blow", and attached to the tailpipe. With a soapy solution, you can find those annoying leaks.