I had my rear camera go blue. After scanning with forscan and checking all the wiring harnesses, I verified the IPMB was bad. I have bought a replacement and intend on installing it tomorrow.

Can anyone confirm the procedure to replace the IPMB?

From my understanding it is scan the current module, record the code in forscan, pull the IPMB, replace it, copy over the old code to the new module?

I have the backup trailer assist, do I need to recalibrate this? How would I do that?

 

What year?

 

2019 xlt

 

...

 

thanks. In the IPMB pdf one of the 2nd points says:

“Using a diagnostic scan tool, complete the PMI process for the IPMB following the on-screen instructions.”

What does that mean?

 

PMI
Programmable Module Installation,

basically you need an IDS to download the old module configuration before removing it and then upload it to the new module, if that can't be done then you have to either do 'as-built' or tear tag to program it

 

sorry you have to dumb this down for me a bit more. I am new to Ford’s.

I bought forscan, my understanding is I go into original and save the as built and then reprogram that into the new module. Is that the same as above or am I not understanding?

 

pretty much

 

I replaced the IPMB and still have a blue screen for the reverse camera. I thought for sure that was the issue as I checked all the harnesses and ran forscan and had a dtc for it.

put the new module in, changed all the values to match my old ipmb, the dtc is gone but still doesn’t work.

I am seeing as of today an IPMA - C1001 code and FCIM code B1083 for some recirculating damper system. I don’t have lane assist.

This sucks, I really wanted my damn rear camera to be working

 

Just asking...

Does the APIM have the latest Sync 3 software?