When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Have you been able to disbale keyless entry? I tried
but after change I had key not detected on my dash and keyfob didn't work so I came back to factory settings
Are you wanting to disable the keypad on the driver's door? If so, use the value below:
726-37-01 x*xx xxxx xxxx Keypad Enable Cfg: 0=disabled, 1=enabled
Is there a way in Forscan to remove entirely the Android-Auto functionality? I totally removed it from my phone but when I plug in the phone I still have to put up with the phone trying to make me use it again and all the pauses and screen blips and such until it realizes it will not get another sucker and goes away. I hate this application so bad that it makes my blood boil to even be reminded of it I want it totally out of my life like it never existed. TIA!
Can't it be disabled in the settings in Sync? I think that you can do so for CarPlay.
On my 19 limited I changed the code for the Fake eng noise ACM 727-01-01 (X0XX) like stated and I still hear it----I switched it back to 2 (default on) and it sounds the same to me, any guesses to what is going on?
Hey guys
new to this forum ,trying to hook up to my 2018 raptor and getting this message .using a three year old laptop with windows 8.1 and a brand new device from amazon that I just got today
Toggle the switch to HS-can. See the arrows on the OBD plug side? Connect with that setting then watch for the prompts from FORscan. It also helps to thoroughly read the tutorial and watch the videos before you do anything.
Thanks for the fast reply . I do have the switch on that setting . This drivinyme nuts
ps I e read so much on this and ya we watched you tube videos
Originally Posted by Wicked ace
Toggle the switch to HS-can. See the arrows on the OBD plug side? Connect with that setting then watch for the prompts from FORscan. It also helps to thoroughly read the tutorial and watch the videos before you do anything.
Last edited by gto19; 03-29-2019 at 07:37 PM.
Reason: Blah blah
Try setting "connection type" to FTDI. I forget why but it's where mine is and I have no troubles. If you look through the Forscan forums you will find a lot of this info and better understand the reasons why. But if you are like me and have old timers you'll soon forget. There is a post on the forum that goes through how to tune your connection. Not that mine was slow but after the tweak it's instantaneous.
Last edited by Wicked ace; 03-29-2019 at 07:45 PM.
03-29-2019, 01:32 PM
