To remove the old hub, I used a flathead screwdriver to pry the left edge up an bit, then two paint can openers to pop it out. Worked like a charm.

 

It looks like you're using the wrong updater. The non-nav needs two separate USB sticks and you swap them when prompted. There is no "single part, non-nav" version. The single part is for NAV only. The two-part is for non-nav.

 

^^^^This

 

I just tried the update and had the same results. I followed the steps exactly as the readme states. According to that file you DO NOT need two separate USB drives. After file 1 was complete I removed the USB, shut off the truck, came inside to delete files on the USB. I then extracted file 2 to the same drive and continued on with the install only to have the same results as Grumble.

Edit: This is the link that I used for downloading

 

Hi all I've pretty much read all through this thread as well as some stuff over on the Fusion forums and I still cannot get 2.2 installed. I have a 2016 F150 XLT built in August 2016, it came stock with sync 3 v2.0 NON-NAV. I have a Samsung Galaxy s6 Edge on Verizon but cannot get android auto to work, when I plug in it immediately adds the buttons to the screen however after a few seconds an error comes up "usb device stopped responding" or something like that, and won't go away until I unplug it. I have tried all sorts of usb cables including several genuine Samsung ones and I have also tried every version of android auto there is, still nothing. Somewhere I read about another guy with an S6 having a similar problem and I believe he mentioned that updating to 2.2 fixed it. I downloaded a "2.0 to 2.2" update from the fusion forum and regardless of format type or sd capacity (tried at least 4 different usb drives and sd card with adapter and even redownloaded the file) every time I get "MEM_ERR01". Any thoughts?? Any feedback is much appreciated! I mostly just want Google Maps to work. Also I was going to upgrade the USB hub not so much for iPhone compatibility because I have no apple products but I read somewhere that the old hub is less than 1 amp and the new hub is 2 amps, if I do get android auto working having a 2 amp charge would be far superior to 1 amp or less which will barely maintain a charge on my phone when in use and I believe this is also why my truck does not like usb 3.0 usb drives, can anyone confirm this as well?? Thanks again!!

 

Thanks, my upgrade from 2 to 2.2 was a success, it took about 20 mins. I plugged in iphone 7+ and NO carplay.....guess I need the new usb hub.

 

Finally worked, 2.0 to 2.2

 

That was the problem. I did the 2 x USB method and it worked just fine.

 

2.0 had CarPlay, you just need the new hub to enable CarPlay support.

 

Quick question I noticed on my non nag 2.2 after i have my iPhone 6 (with latest IOS)plugged in to use CarPlay and then unplug, it takes a long time Tom Rockne for via Bluetooth. If my wife's phone is in the truck it connects to that one first (mine is set up as the primary). I have deleted the phones and re-paired and same results.