Can bliss be added?
On Led equipped 2018’s pin 4 is used for canbus and 15 is unused.
As BGG already said, just depin the existing wires in 4 and 15 on the chassis side of the harness and add the wires from his harness.
Last edited by Ryan B; Nov 28, 2018 at 02:23 PM.
Junior Member
Joined: Nov 2018
Posts: 2
Likes: 0
I have a 2017 King Ranch (600a) and would like to add the BLIS. I couldn't find much info on this particular trim in the forums though. I have the 22pin mirror connector (600a has power fold, puddle and spot lights), so I should be able to get the glass with LED and connect it in the mirror. After that I'm at a loss. I have the LED tails with amber turn signals but no BLIS. Do I need to change out the entire lamp housing or can I get the sensors only. If I change the housings, how much else needs to be changed? I'm in the early stages of research on this, and just curious how much different it is than the writeup that specifically excludes the KR tails.
I have a 2017 King Ranch (600a) and would like to add the BLIS. I couldn't find much info on this particular trim in the forums though. I have the 22pin mirror connector (600a has power fold, puddle and spot lights), so I should be able to get the glass with LED and connect it in the mirror. After that I'm at a loss. I have the LED tails with amber turn signals but no BLIS. Do I need to change out the entire lamp housing or can I get the sensors only. If I change the housings, how much else needs to be changed? I'm in the early stages of research on this, and just curious how much different it is than the writeup that specifically excludes the KR tails.
Junior Member
Joined: Nov 2018
Posts: 2
Likes: 0
OK. So the separate signals for turn and brake isn't an issue with the new tail light harness. I was afraid they were separated further up stream. I assume, I'll still need to run the 4 wires or buy the drivers side full length harness, correct?
