I need help with 2018 owners who has done this and working----Figured it would be better to start a thread to be better seen by 18 owners!

​​​​​​Hopefully someone has this working and why mine do not----I did the forscan procedure--but mine will operate like this--

** I select the mirror via push button then select reverse and it tilts down! Now when I go to drive or park it Stays DOWN until I deselect the mirror and then goes back up to normal----I know from reading on here its supposed to go back to original position when going to drive or park, so what Im I missing here lol? I have read and done the memory procedure a few times and I get same results!

 

mine take a bit of driving or being in park to reset.

 

That really doesnt make sense to me!! But mine still will not go back up lol---hopefully someone will figure it out!

 

You have a 18---can you check your values and tell me what you put in via Forscan please

 

I cannot believe no one with a 18 has not performed this--I may be wrong I guess!! Im still trying to get this to work correctly!!!

 

Folks, I've been in touch with one of the FORScan organizers and confirm based on messages we've exchanged that it's possible that there were some new changes introduced model years 2018 & 2019 where the FORScan reverse tilt mirrors is not working correctly or in my case (2019), not working at all. I tried both codes "F****" then restored DDM & PDM back to AsBuilt, reprogrammed with adding the C to "FC**" (following instructions) and still no luck. Mine did not tilt at all neither driver or passenger side mirrors.

FYI, my other FORScan changes worked perfectly, the reverse mirrors being the exception. Best option for the tilt is to program and save Seat Memory 3 with tilted mirrors, use that when reversing, then going back to seat memory 1 when moving forward again.

 

This does WORK on 18's and my new 19----The values on the Forscan sheet are correct, I think I was just getting the program procedure wrong, but the tilt mirrors work Perfect!!

 

Nice Necro...
03-06-2018, 01:40 PM

BOOOOO.

 

Do you recall if you used the F*** value in both DDM & PDM or the FC** on 740/ 741-13-01 values for your programming?

 

I do not remember, I will have to get into my values and let you know!