FOR A 2007 F150 5.4 AUTO set the shift points at +300 rpm's on each one. Set the rev limiter to + 500 rpm's. The shift firmness is a yes/no question; this is a good feature it firms up the shifts & keeps the clutch pacs from slipping so much. This cuts down on wear & heat build up in the transmission. The speed limiter can be raised above 100mph for speed rated tires or lowered to govern the vehicle speed. The engine tuning is based on either regular fuel or premium. It will recalibrate the speedometer or odometer for different tire heights or gear ratio changes.
Thanks, Gary at Hypertech

 

Went out to program the truck with the settings Gary recommended and I got an error code 93: VIN incompatable; call tech support.

I did... Still waiting on a solution from "engineering"

I hope they get back to me soon, cause I'm taking the truck back into Ford monday for some work, and was hoping to put it back to stock before doing so.

We'll see what happens.

 

Thanks Gary. Big difference from my set up.

 

Aloha Gary

What is the settings again for my 2010 5.4

Mahalo!

 

Seeing that the Max energy Hypertech is for engines 5.4 motors '04-'10 I'm assuming they may be the same settings he gave me for my '07.

 

Settings for the 2010 F150 5.4 : Select the octane, regular or premium , set the shift firmness at 50%, set the shift points at +300 on the 1-2, 2-3, & 3-4, leave 4-5 & 5-6 stock, set the rev limiter at +500. The speed limiter can be set down to govern between 25 & 80mph or up above 100 based on speed ratings of your tires. If you are running your stock thermostat you can set your cooling fan for the 195 setting. If you change your tire size or your gear ratio you can program in the new setting to correct your speedometer. Let me know if you have questions.
Gary @ Hypertech

 

Well thanks to Kenny, Joe and Gary at Hypertech I got everything straightened out! Thanks guys!

 

Hypertech Max Energy (42501) for a 2010 F150 4.6L 2V with an Injen CAI and cat-back dual exhaust... thanks!

 

Did the setting for the 2012 5.0 work that Gary sent you.... I have the same truck 2012 f150 5.0 (fx2) lifted with 34" tires... I just bought a max energy and want the best settings.. Any help would be great!!

 

The settings Gary posted is what I went with and I have a noticeable increase in horsepower and torque. I haven't timed a 0-60 but I can tell it's a good bit faster. After I run my regular octane out I'm going to fill up with premium fuel and run setup again.

Anybody else running Hypertech post your results.