Hey guys! I just thought i'd throw a couple pics of my newer interior up.....the truck i got it from only had 40k miles when wrecked. My factory seats didn't have headrests and they were light grey and WORN OUT!! These seats are much darker and in MUCH better condition.

 

Nice.. Where did you get the carbon fiber lookin stuff on the door lock panel??

 

It's 3m di-noc vinyl that i did all my panels with, and the center panel around the radio. It made a BIG difference in the interior!!

 

 

Awesome job with the vinyl. Were they diffiucult to put on?

 

Looks awesome.. X2 on how hard it was to install and also how much would I need to order?

I have a scab BTW so just the Radio bezel and 2 control panels

 

This should be enough right??

http://cgi.ebay.com/ebaymotors/3D-Tw...item3cb90a2b81

Mainly I want to make sure I can cover the radio bezel with one peice of vinyl..

 

Vinyl is kind of difficult to install....just make sure it's clean clean clean!! Use Windex followed by some good alcohol (for you!!! j/k) But seriously use 70-90% or denatured. And have a good heat source that won't fry it. I do this kind of stuff for a living so i'm used to it.

I'd rate it about an 7.5 out of 10 on the difficulty meter. That's only because it's time consuming for something so small....and it's hard to hold stuff while doing it.

 

Just measure the height and add a couple inches to make it easier to work with. Once you get it down you can cut it closer.

 

Great job on the interior!