Engine vibration
Senior Member
Joined: Sep 2013
Posts: 1,267
Likes: 85
From: Behind You
Why the front cover removal post? Huh?
The OP said he replaced the converter. I asked about the flywheel and he said it was ok. Did you notice that in w01ves first list that the converter was listed as a problem? That goes back to me asking about the flywheel. I've seen Ford's with AOD (4r70) transmissions, where the flexplate/converter would not center. It would give you a constant vibrations. .
The OP said he replaced the converter. I asked about the flywheel and he said it was ok. Did you notice that in w01ves first list that the converter was listed as a problem? That goes back to me asking about the flywheel. I've seen Ford's with AOD (4r70) transmissions, where the flexplate/converter would not center. It would give you a constant vibrations. .
The 4.2 Crankshaft pulley is bolted on the Vibration Damper.
Senior Member
Joined: Sep 2013
Posts: 1,267
Likes: 85
From: Behind You
Senior Member
Joined: Sep 2013
Posts: 1,267
Likes: 85
From: Behind You
Just remove the Crankshaft Pulley from the balancer and turn the pulley clockwise. Do it until the vibration is gone. If it's vibrating too much it will deform the rubber in the balancer.
Last edited by w0lvez; Jun 12, 2016 at 08:57 PM.
Senior Member
Joined: Sep 2013
Posts: 1,267
Likes: 85
From: Behind You
Check this site. They have a 1 piece design of Harmonic Balancer Crank Pulley
http://monsterautoparts.com/FORD/F15...c_balancer.htm
Replace the Front Crank seal.
http://monsterautoparts.com/FORD/F15...c_balancer.htm
Replace the Front Crank seal.
Last edited by w0lvez; Jun 12, 2016 at 09:10 PM.