I've read post after post and searched thread after thread. I wanna order a 40 flowmaster for my 08.wanna leave every thing else stock just gonna get the factory cut out and new welded in....here's my question what size do I need,as far as offset and inlet/outlet pipe size.

 

2.5 in 2.5 out...I had a 50 series welded in.

 

Straight or is there an offset.

 

Offset and added a tip

 

Do you remember which offset? I can order one off internet lots cheaper than buying from the shop just wanna make sure I get the right one

 

Crawel under the truck with a tape measure Bubbabud

 

Simple and effective. Lol thanks

 

Fastgsx what info did you end up with as far as the offset? Get it welded up yet?

 

Not today my friend.didn't even climb under. It was all about the grass cutting today.I will post tommorow.

 

2.5" center in with a 2.5" offset out