I'm getting a TSC or UWS toolbox and I was looking at my truck... Am I gonna have to drill through metal to put it on?? How are y'all putting y'all's on?

 

My was drilled before I had my truck

 

So there as a big hole? The only thing I see is where the plastic bed rail was pulled through

 

had one on my last truck that I had to drill holes in the toolbox for the J bolts.

 

I just did one earlier. I made some j bolts and bolted it down no holes in the bed.

 

The J bolt is the way to go so you wont have holes in your top rail. Also I recommend you put some thicker rubber or something between your toolbox and the plastic rail just because the diamond design will press into the plastic over time. I found a plastic flap I cut up to fit underneath.

 

Here is what I use:


http://m.autozone.com/autozone-mobile/en/accessories/Daws-Better-Built-No-drill-truck-box-mount/_/N-25k0?id=416175


Quick and easy to install. I leave them on when I take my tool box off for big loads.

 

Could someone post a picture of theirs when they get a chance?

 

when you buy your new box it will have the hooks needed to mount it without drilling into your truck. If not then someone took them and ask the seller to provide them.