Plan on converting my stock bulbs to LED bulbs and I just need confirmation on a few things. From what I've read, I will need a resistor for each bulb (4 total) because it won't match the front's speed when I turn on the blinkers if I don't. Correct? And do I need a resistor for the back up light bulb? I'm guessing no, since it doesn't act as a blinker.

 

You are correct sir, 3 ohm load per side but only on one bulb per side. no resistor is needed for the backup lights. Where are you ordering these from?

This thread will explain how I did mine:
https://www.f150forum.com/f38/change...s-leds-146376/

 

My primary concern is the reverse light bulb cuz I recently nite shaded my tails and although the lights show through really good, I'd still like a brighter reverse light so I can see out of my reverse camera. I saw a pair of 921 LED white bulbs on amazon for $20. I believe they are from Putco. I looked at gorecon.com and they were $39.99 + shipping for 2 of the same bulbs

 

I got two high power 3w bulbs off eBay for like $20 bucks or so and they are super bright! Check them out.

 

Are they LED or just regular bulbs? Sorry if I ask any stupid questions. Im new to this and I'm trying to figure everything out as I go along lol

 

Haha that's okay, yes they are led I'll try and find the link for ya.

 

Thanks, I appreciate it!

 

Here is basically what i used, I couldnt find the seller I bought them from but these are the exact same ones i have in my reverse lights.
http://www.ebay.com/itm/2-High-Power...8396be&vxp=mtr

 

I tried LED taillights and I think they're not worth the trouble unless your truck comes with them from the factory. I upgraded my regular XL lights to blacked out FX2/FX4 version and they look great. No resistors are required!

 

Good timing op! I'm looking at doing the LED conversion myself. Hope you don't mind if I hijack your thread real quick...

What are the sizes of the brake/turn signal bulbs and the reverse bulbs? And I read that you need resistors for the brake/turn signal bulbs?