Help needed after amp install
Senior Member
Joined: Mar 2016
Posts: 3,992
Likes: 1,220
Originally Posted by 2017bluetruck
I get a short humm from mine when opening the door, but have put that to the system powering up at the fuse box and supplying power to the Key amp, sub amp. After that initial humm it is dead quiet till I turn on the radio. I wired the Key and sub power wires to the foot-well fuse panel with a fuse tap. Grounded the Key to the dash framing metal the sub to seat anchor bolt checking both for ohm resistance.
I do not think the center should be connected for the Key tuning program, it certainly isn't needed after setting the Key amp! KM
I do not think the center should be connected for the Key tuning program, it certainly isn't needed after setting the Key amp! KM
Thread Starter
Member
Joined: Aug 2018
Posts: 43
Likes: 0
I literally matched the wires on the FOR-11CK to the amp and went with it. Power and ground needs to come from the battery I'm assuming? If I do that, should I just go ahead and run a remote wire to a source as well? Now I'm confused about why this harness is marketed as plug and play. haha
Senior Member
Joined: Mar 2016
Posts: 3,992
Likes: 1,220
Originally Posted by Brandon404
I literally matched the wires on the FOR-11CK to the amp and went with it. Power and ground needs to come from the battery I'm assuming? If I do that, should I just go ahead and run a remote wire to a source as well? Now I'm confused about why this harness is marketed as plug and play. haha