Upgrade to 8" MFT?
#31
Senior Member
iTrader: (2)
So the base model APIM harness reaches just fine for the MFT APIM...thats good to know. Then it can be done, its just like the Mustang setup then. Just have to rewire things, use the correct bezel (btw the bezel has the VIN programmed into it), add the remaining MFT hardware and fine tune programming.
#33
Senior Member
Thread Starter
So the base model APIM harness reaches just fine for the MFT APIM...thats good to know. Then it can be done, its just like the Mustang setup then. Just have to rewire things, use the correct bezel (btw the bezel has the VIN programmed into it), add the remaining MFT hardware and fine tune programming.
#34
Senior Member
iTrader: (2)
So this is where I am at right now. I made the pin movements from the old APIM configuration to the new APIM configuration and she fired up. I will tackle getting the bus and backup camera wiring done later this week. The date is off and the compass isn't showing up. So I have a little more research to do. Sat works, sync works, Ac controls work, fm and am are working. So far really happy with the purchase. Can't wait to get it all dialed in.
#35
Senior Member
Thread Starter
perfect. I haven't tapped into the can bus or swung over the camera leads as I need to get the wire harness repair parts.
Last edited by antho; 02-23-2016 at 10:08 PM.
#36
Senior Member
Thread Starter
I bought the bezel(FL3T-18E243-CDJ), APIM(FL3T-14F239-CE) Screen(not sure of part #) and ACM( FL3T-19C107-HG)The only thing my bezel has that my truck doesn't is the heated seat buttons. Doesn't really bother me. Not bad for 500 bucks. This is the non nav.
#38
Senior Member
Thread Starter
Got the WT-1000 wires and plugged up the backup camera and spliced in the can bus for the compass and date. Whole process took about an hour. Super happy with it.
Last edited by antho; 02-25-2016 at 05:43 PM.
#40
Senior Member
Thread Starter