When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Now to get the altitude to display on the sync2 map.
I think you have a better chance of me finding the panic button on remote being a double press than that lol.
BTW: I forgot to mention earlier that when I was playing around in IPC I found a value that suppressed the normal F150 animation on startup on the productivity screen and the display became an instant-on thing. If anyone is interested in that it's:
720-07-01 xxxx xxxx Bxxx
I think you have a better chance of me finding the panic button on remote being a double press than that lol.
BTW: I forgot to mention earlier that when I was playing around in IPC I found a value that suppressed the normal F150 animation on startup on the productivity screen and the display became an instant-on thing. If anyone is interested in that it's:
720-07-01 xxxx xxxx Bxxx
I'm taking my laptop on the trip with me,,,, just in case you find it before we hit the mountains.
Everytime you find something new that Ford has hidden from us l
I get pissed at them...
You need to take a few hours off from this and go drive your truck!
Last edited by Livoniabob; 07-18-2016 at 12:54 AM.
I have the same 2015. Could you walk me through step by step on how to do this on Forescan? I have all the equipment, but not the knowledge of the program and how to navigate within it. I'd really appreciate it.
Been doing a lot of DIY around the house this week so haven't had a chance to test anything until today but here's your Sunday find:
IPC Module:
720-07-01 xxxx xx5x xxxx Engine temp & trans temp numbers appear above gauge
720-07-01 xxxx xx6x xxxx Engine temp only
720-07-01 xxxx xx9x xxxx Trans temp only
Edit: Before anyone asks, this doesn't show boost PSI above the gauge but I'll be looking for that next.
Fing A MAN!
This is a great surprise after canoeing/portaging/camping with my buddies for three days. I would love see the oil pressure as well, but I think from previous thread conversations the oil pressure sensor is a pressure switch not an ctual pressure sensor (pressure or no pressure).
Now I can change the gauges on my Scangauge II to see other values
I have the same 2015. Could you walk me through step by step on how to do this on Forescan? I have all the equipment, but not the knowledge of the program and how to navigate within it. I'd really appreciate it.
There's a video on post #1 in this thread on connecting with FORScan and directions how to enter the programming screen so I'll pick it up from there:
1. Select the IPC Module Configuration (AS BUILT Format) by clicking it and hit the play button at the bottom to take you into that.
2. Scroll down to address 720-07-01 and there will be 12 editable numbers there. Change your value in this position xxxx xx5x xxxx (whatever number you have in the position where the "5" above is, change that to 5) and press the "write" button. You will get a warning about checksum but ignore that and continue with the write.
3. A message will pop up asking you to cycle the start button on & off, hit "ok"
4. Press the square "stop" button at the bottom left
5. Press the Automobile picture on the left boarder at the top, then the disconnect button at the bottom left
That's it, all done
Edit: Example: I originally had the value of 720-07-01 8409 8EA0 604A and then changed it to 720-07-01 8409 8E50 60FA
07-17-2016, 11:55 PM
