When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
From the Forscan thread:Post 9538 and those around it.
If you go into the SCCM module and make the following change (from 0 to 8), it will swap the arrow/center key function on the left side of the wheel with the corresponding radio buttons on the right side.
724-01-01 xxxx 8xxx xx Cluster crossover cfg: 0=disable, 8=enable
If you are brave enough to try to pop the buttons out of the switch, you can evidently swap those too.
This has never bothered me, so I haven't done it...
Good Luck!
Mint. Thanks for posting. I have forscan so will look into it. Are you saying you did the swap with forscan but didn't bother with changing the physical buttons over? That would likely be the route I'd go. I only care about the function., it's only me driving the truck
Mint. Thanks for posting. I have forscan so will look into it. Are you saying you did the swap with forscan but didn't bother with changing the physical buttons over? That would likely be the route I'd go. I only care about the function., it's only me driving the truck
I haven't done either, but others on the Forscan page have...
