Originally Posted by Livnitup

Hold on, out in my truck now trying some values...

Edit: Try this: 760-03-01 3xxx xx

This seems to be the binary bit breakdown for 760-03-01 *xxx xx:
0000 - bold bit is: 0=Hill Start Assist disabled, 1=Hill Start Assist enabled
0000 - bold bit is: 0=ACC disabled, 1=ACC enabled
0000 - bold bit is: 0=Collision Warning not avail, 1=Collision Warning avail

So:
760-03-01 3xxx xx = ACC enabled & Collision Warning available (3 in hex=0011 binary)
760-03-01 7xxx xx = Hill Start Assist enabled, ACC enabled & Collision Warning available (7 in hex=0111 binary)

Originally Posted by OrionPax

I do have hill decent and added the acc. So should I use use 3?

Originally Posted by Livnitup

Hill Decent Control is at 760-03-01 x*xx xx, what I posted above is Hill Start Assist

Originally Posted by vtn98

I have my front bumper Line-Xed. Would I still be able to add this? Will the Line X interfere with the radar sensor at all? Sorry if this has already been asked. I only made it to page 40 of this thread and I kinda want in on this.

Originally Posted by OrionPax

I doubt it would bother it. The sensor sits behind the plastic piece.

Originally Posted by vtn98

The plastic piece is Line Xed as well.

Originally Posted by OrionPax

I can’t say for sure but it’s not that thick of a coating. I think you would be ok. It’s not metal so it shouldn’t block the signals.

Originally Posted by Madcap57

Yeah but it sounds like he will have a real hard time doing the vertical alignment. Sounds like the plastic piece was line-x'd with the bumper. This sounds like new plastic piece would be needed and more line-x.

Don't think he will jump at it now.

Originally Posted by vtn98

The plastic insert was separated before it was sprayed, so I can still remove it. Looks like I might have to put some serious thought into doing this. Especially with it all done with FORSCAN mods. Thanks to all who contributed to this thread. Looks like a fun little project.