I put a Pertronix Flame Thrower HV 60,000 volt e-core coil on my truck, it has about 2500 miles on it since I installed it, my truck shut off on the way to church this morning, I put the factory coil back on after checking and not getting any fire and it started right up and runs fine, no codes or any problems. The flame thrower was 0.45 ohm, do I need a different model or just a new coil?

 

ICM and/or PIP.

 

X2, what Sean said.

 

It runs perfect with the factory coil back on, the problem is the pertronix coil. are the junk or did i get a bad one?

 

How long have you had the old coil back on?

 

I must have read your post wrong. Yea the coil must be no good.