Hi,
I have an '89 F150 XLT Lariat regular cab with a bench seat. Someone local has a bucket seat interior with a console from a '92-'96 F150. Would these bolt straight in? Link to ad below:


http://louisville.craigslist.org/pts/4182998096.html


Thanks

 

Probably.... but if it don't you could just drill holes in the floor. I'm bout to do this to my 95 but with the split bench seat

 

pretty much all mid 80's-mid 90's, f-150 interiors are very similar and should mount with almost no problem, depending on the cab size and a few factors you may need to make some new mounting brackets, or modify the old ones, but it should take you just a night in your garage to do it. but to answer your question they will probably not bolt up to the existing hardware and holes exactly.

 

Yeah, went and looked at them with a tape measure in hand and they don't line up. Found another post on here that detailed using square stock to adapt any seat to the existing mounting holes. I'm now looking for a pair of leather buckets out of an Explorer to put in. Thanks for the input guys!

 

You need to find of of these seat sub assembly mounts off Ebay, Craigslists, or salvage yards. This sub assembly mount will allow you to attach a set of 40/20/40 seats or 2 captains chairs and a center console. Once your seats are attached to this sub assembly, you simply bolt it in place using the same identical mounting holes left by your original bench seat. I just did the exact project in my 1996 Ford F-150 reg cab 4X4 bench seat.