Edelbrock intake and BBK throttle body install
11-11-2018, 07:19 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Edelbrock intake and BBK throttle body install
Hey everyone my names Mike and im brand new to this site. Im 19 and in college and I want to install an Edelbrock 3841 intake manifold and a BBK 61 mm throttle body on my f150
-1995 f150
-5.0/302
-single cab 4wd
only upgrade is cat back exhaust
Why I want to make the install - I want better HP/ torque/ throttle response and I want to do as much as I can on this truck by myself, this seems like a good start because I wont have to dig that deep in the engine.
I have a good idea on how to do this. I have a binder with all the parts ill need including replacement smog parts, sensors, gaskets, ect. and a break down of the tear down/installation process
I've never taken on a project like this, does anyone have any experience with this and would like to share any knowledge they wish they knew before doing so?
What are some problems I might run into?
Good tips?
Thank you, I appreciate any help
-1995 f150
-5.0/302
-single cab 4wd
only upgrade is cat back exhaust
Why I want to make the install - I want better HP/ torque/ throttle response and I want to do as much as I can on this truck by myself, this seems like a good start because I wont have to dig that deep in the engine.
I have a good idea on how to do this. I have a binder with all the parts ill need including replacement smog parts, sensors, gaskets, ect. and a break down of the tear down/installation process
I've never taken on a project like this, does anyone have any experience with this and would like to share any knowledge they wish they knew before doing so?
What are some problems I might run into?
Good tips?
Thank you, I appreciate any help
