Clonking noise from front end
#11
Junior Member
Thread Starter
Hi, i installed the all new steering linkage and tie rod ends , did not solve the problem , all ball joints on the wheels are ok and i also could not find any play in the radius arms or axle bushings , when i mounted the linkage i found that the rod where the pitman arm attaches to the Power steering gear box has some play? could that be the problem?
thanks
thanks
#13
Junior Member
Thread Starter
Picture
Hi, not sure if it is that part, here a picture and i will also change the radius arm bushing just to be sure , any ideas what is the best way to change the radius arm bushings ?
Thanks
Thanks
Last edited by Ulli; 08-29-2017 at 09:41 PM. Reason: picture
#14
Senior Member
Assuming it has the bolt on brackets, that isn't a bad job at all. Knock the big nuts loose, take all the bolts out of the brackets change bushings, put it back together. That is the one place I use the urethane bushings. An impact wrench really helps, but it can be done with a big ratchet / breaker bar.
The following 2 users liked this post by Ulli:
Eric Fullerton (08-29-2017),
justintendo (09-03-2017)