ND FX4 - thallendorff
#32
Senior Member
Thread Starter
Haven't been overly busy on major modifications but have added the Full-Race to more areas of my truck and couldn't be happier.
Full-Race CAI - PTM Blue Flame Metallic Replaced K&N 63 setup for the dual air filter setup, plugged port to wheel well, and opened up front flaps to draw air in through front of vehicle.
Full-Race Catch Can - Replaced UPR dual can setup for the PCV delete and cleaner look.
Shot of both new installs in the engine bay.
Full-Race CAI - PTM Blue Flame Metallic Replaced K&N 63 setup for the dual air filter setup, plugged port to wheel well, and opened up front flaps to draw air in through front of vehicle.
Full-Race Catch Can - Replaced UPR dual can setup for the PCV delete and cleaner look.
Shot of both new installs in the engine bay.
Last edited by thallendorff; 08-23-2018 at 12:43 PM.
#33
Senior Member
Thread Starter
Finally got around to deciding on a set of wheels and offset. Just a little sticking outside the fender but gives it a nice stance from the front and rear.
Fuel Coupler +01mm offset
Fuel Coupler +01mm offset
#35
Senior Member
Thread Starter
Full-Race parts are some of the finest built and assembled add-on's I have found for my truck. There is a reason I continue to add their stuff from the catch can, cold air, and here soon will be getting their exhaust/downpipe setup. In addition I am looking to take out my current IC and pipes and have them powder coated to match the truck, Blue Flame Metallic. Will post picture once complete.
#36
Senior Member
Thread Starter
Will be getting some new suspension components for the pickup over the next couple months. Planned build will be a 6" BDS lift w/ custom 6" Icon coilover w/ reservoir CDC and rear piggyback CDC's and Icon delta joint UCA's. Hoping and praying the extended/collapse measurements were accurate per Fox