2012 Raptor , driver door code unlock help no.codes truck was a gift how do I get the
#3
Thank you 100% correct , I removed panel sticker there, 5 numbers with a Letter, l
The letter L at the end of the 5 numbers has no involvement , again Thank You
do you know if I ever need a Radio unlock
code ?? Just curios if I change battery , or is all ok if one changes batt
do you know if I ever need a Radio unlock
code ?? Just curios if I change battery , or is all ok if one changes batt
#4
If you have both sets of keys...
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.
#5
Senior Member
If you have both sets of keys...
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.