Belltech Belltech Drop Spindles with Belltech drop struts
#22
#23
Junior Member
Thread Starter
I was able to get my camber and toe perfect but it is almost impossible to get caster in spec. Also note that my lower control arm bolt holes have been elongated
#26
The following users liked this post:
bluelinefreedom (04-14-2023)
#29
If I recall you used the Maxtrac 2" drop spindle, I was curious what size wheels do you have (are the 20" ford factory wheels or after market), did you have to trim the lower ball joint stud. I have a 2020 F150 wanted to stay with a 2" drop, but based on all the research I did, Maxtrac and belltech 2" drop spindles need the lower ball joint stud trimmed for the Ford 20" factory wheels to fit and Maxtrac you can't reinstall the brake dust shield. I'm between the drop spindles or go with the IHC upper lower control arm 3" front drop using the factory front shocks. Any feed back you can give would be helpful. Thanks Pete
#30
Lost in Time
Join Date: May 2011
Location: North Dallas Forty, OC California
Posts: 523
Received 220 Likes
on
99 Posts
If I recall you used the Maxtrac 2" drop spindle, I was curious what size wheels do you have (are the 20" ford factory wheels or after market), did you have to trim the lower ball joint stud. I have a 2020 F150 wanted to stay with a 2" drop, but based on all the research I did, Maxtrac and belltech 2" drop spindles need the lower ball joint stud trimmed for the Ford 20" factory wheels to fit and Maxtrac you can't reinstall the brake dust shield. I'm between the drop spindles or go with the IHC upper lower control arm 3" front drop using the factory front shocks. Any feed back you can give would be helpful. Thanks Pete
The following users liked this post:
VintageBikesUSA (02-25-2024)