steering column rubbing on lower radiator hose
11-28-2011, 02:24 PM
#1
Member
Thread Starter
Join Date: Aug 2011
Location: Garland, Texas
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
steering column rubbing on lower radiator hose
Ok so i just replaced my heater core about two weeks ago and i just noticed i am leaking antifreeze/water. So i got under and looked and it seems that my steering column is rubbing or grinding on the lower radiator hose/clamp, also contacting where the hose meets the engine. I did have to lower my steering column for my heater core so i was just wondering if i may have just reinstalled it wrong, but my steering feels fine i can just hear it squeaks or grind when i turn the wheel. Think i should just lower it again and like adjust it or what? Thanks for any imput
12-11-2011, 04:51 PM
#4
Well, if it was not rubbing before, then something was not installed correctly. Either the hose is not physically where it was before (ie, different bends, length) or the column is in a place where it was not before. This may be more of an issue if the truck is lifted, torsion bars cranked, etc.
12-11-2011, 05:44 PM
#5
Member
Thread Starter
Join Date: Aug 2011
Location: Garland, Texas
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
I also got an alignment right after so im not sure if that could be a possibility of why it may be rubbing. This is the best picture i could get
Last edited by Anythingmuddy!!!; 12-13-2011 at 01:40 PM.
Trending Topics
12-14-2011, 08:43 PM
#10
Member
Thread Starter
Join Date: Aug 2011
Location: Garland, Texas
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
well i think it may be the motor mounts are bad and making the engine sit low enough to rub on that intermedite shaft...any one know of any good videos or how-to's on changing the motor mount on my 4.6 1997? Thanks everyone