hi there im putting 99 expedition electric seats in my 98 reg cab none electric so im going to have to run my own wires my ? is i dont know what wire goes to what i cut the old wire past the plug in clip and so i had plenty of wire on the

drive side seat there is four wires red black white and green

passanger seat is red black and white i plan on tapping in to my fuse box to get my hot wires inless there is a better place
thanks Dustin

 

Here's your schematic for the wiring for your power seats for 98=99 F series. Hope you can work it out. The colors you described are the same for both years.

 

thanks for getting that found out the motors where bad so what i did was switch the seat base out with my old manual works like a charm and i didnt have you hunt down wires will post pic later oh i all got the center console and all the brackets to put in my truck

 

If you ever feel like replacing your motors just wire it rite to the battery. Throw a small fuse on too. That's what I did on mine. Not realy as clean in the engine bay but its a whole lot easyer.