ok 01 screw 2wd. looking at putting a 2" coil spacer on. once thats done.. it will be a little bit over 35" (from the ground to the top of the fender on the outside) and a little over 34" on the back.....I want it level, i know the measurements are off but will it look like its squatting in the back? or could i put a 1" spacer in the back to even it out? i would do a 2" in the back but that would make the same look now but everything is higher.

ideas please.

 

it want look unlevel to bad unless your just a freak lol that pays attention to everything but mine sits like 2 1/2 higer in the front lol but thats how i wanted mine to look but thats just my opinion but 1 inch aint to much

 

well I do haul a lot of and dont want to put one cinder block in and it looks like it weighs a ton, you know waht I mean? do they even make a 1" block?

 

yeah you can buy them from autozone for 30 bucks with u bolts and all

 

but i mean i haul alot to but i pput bigger leaf springs in the rear so it dont sqaut as bad but i pull goosenecks so it puts more weight further up on the truck so it dont sqaut as bad

 

I was thinking about putting in a add-a-leaf but that would cost more than a 1" block.

 

yeah and add a leaf would give more lift than the 1 inch block

 

true true.

 

i would prolly go with your first idea with the inch block in the rear but thats just my opinion

 

thats what Im thinking. and even if the tail ends up being just a touch higher ill be happy, as long as it doesnt look like its squating.