Its happening AGAIN!!
#1
Senior Member
Thread Starter
Its happening AGAIN!!
So I just drove from Marquette MI to Green Bay WI and now my truck is jerking from 1st to 2nd.. The last time this happened i ended up replacing the tranny. I can't see the exact same problem happening again maybe it was mis diagnosed? Could i possibly disconnect the battery to reset the comp.. Any Ideas?
#2
So I just drove from Marquette MI to Green Bay WI and now my truck is jerking from 1st to 2nd.. The last time this happened i ended up replacing the tranny. I can't see the exact same problem happening again maybe it was mis diagnosed? Could i possibly disconnect the battery to reset the comp.. Any Ideas?
#3
Senior Member
I test drove an F-150 super-cab 4x4 with the 5.4 once, it had a hard shift from 1st to 2nd, asked the guy about it when I got back, he said it had been that way since he had the tranny rebuilt, I didn't buy it because I was nervous about that.
#4
first love f150
Join Date: Feb 2010
Location: Pomona, CA
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
i had that same problem but it was one of my cars, first thing i did was change the sensor on the intake because it wasn't reading the right amount of air, and that fixed it
#6
Bleeds Ford Blue
That code could be causing the computer to try and compensate for it. Bank 1 sensor 2 is normally the downstream O2 sensor in the exhaust if i'm not mistaken. bank1 designates the driver or passenger side - i don't know which though.
#7
Senior Member
Thread Starter
So i disconnected the battery to reset the comp.. light stayed off and no shifting problems the whole way home! ? so i need to figure out whats setting these codes