Ok I decide to go ahead and pull my headlight switch to cut the ramp so my fogs would come on whenever I wanted and splice wires together do they'd be on with hi's my question is how the hell does the actual ****/switch come off the switch assembly

 

I believe it just pull straight off, i know a buddy of mines switch would easily pull off,

 

I've been pulling on it for half an hour lol

 

Lol hmmm id just pop the whole switch assembly outta the dash and see if you can pry it with a flathead....im sure someone with more knowledge will chime in

 

http://www.svtlightnings.com/svt/how...s/foglamps.htm

I did mine a while ago, so I don't remember exactly, but I know I followed this write-up. I think I did the same thing and just pulled everything apart far enough to get in and cut a ramp.

 

Reach behind the dash there is a small butten on the side of the switch push the butten and pull the **** and the **** and shaft will pull out of the switch you can then remove the switch if you cant find it go to aparts store and ask to look at a switch.

 

I never could just get the **** to come off but got the assembly about of the housing I got the guide notched and wire spliced housing is glued back together and back in the truck works nice fogs w/parking lights and hi beam
Thanks for all the info and links

 

..

 

I'm on my phone and not sure how to put a link on here but there's a thread called. " mod lights "there is a link in with full write up if you have a 00-03 you'll need to scroll down threw the link because the trimming of the guide for the switch is different then the 97-99

 

I got it from a post a few lines up. I just didn't look earlier. Thanks for the reply.