Hey guys i have a basket ball size dent near the top right of my passenger tire on the fender/bed i guess you would say, i tried the plunger method and it will pop the big part of the dent out but once the plunger looses suction the dent pops back in. Granted its not a pretty and smooth dent it has a couple of areas that are going to be hard to get out any ideas?

 

What I would do is take the suction cup and pull the dent out... while pulling on the dent with the suction cup.. take a body hammer with tape on the head of the hammer(so it wont scratch the paint) and gently hammer around the dent where the metal starts to bend in. Just go around it a few times and let some pressure off with the suction cup.. it will take time and patience but it will come out and shouldn't look too bad as long as you go easy on it.

 

could you recomend a link for a how to video or somthing i couldnt find any help on youtube.

 

I got to get back home im on my phone right now and ill see what I can find

 

There's a paintless dent repair forum that might be helpful.

 

on the website?

 

Well I couldnt find what I was talking about But hope this will help.

I havent done this yet but its worth a shot... its just using a hair dryer and compressed air turned upside down since it comes out cold that way

 

You have any pics? If anything body hammer as mentioned with padding

 

Ill post a picture up tommorrow its a little dark right now thanks guys appretiate the vid too