so i went fishing saturday and drover through some rough terrain/mud/sand, not aggressively, just cruised through.
i turn the 4x4 switch and sounds like its switching on.
i end up stuck in the sand, my front wheels are spinning? i have driven through this sand before and got through fine.
any idea what could have happened?
this is my first 4x4 so this is all new to me?!

 

did ur light come on. if not ur *** just got stuck if u say ur front wheels r spinning hahahaha

 

yea next time it happens just roll up the windows and bury the throttle an it should come right out welcome to 4x4

 

haha yea..make sure your light comes on and also stock 4x4s the power wheels are cadi-corner i think front power wheel is driver and rear is pass.

but yea slap that bitch in 4hi/4low and ***** the wall and itll pop out

 

na without a locker or posi-trac power goes to the tire with less traction. which is stupid.

 

haha

 

my bad i jacked up my post! i meant to say my front wheels WERE NOT spinning. my 4x4 light came on, but the front tires were NOT spinning. right under the 4x4 light another light came on that said LOW RANGE. im not sure what that means.

 

ok well that was some important info to leave out haha. uh all i can think of is theres a fork in your t case that engages your 4x4. i dont know its never happened to me but ive heard of it before. im not sure what it takes to fix it though.

or if its a 4x4 **** you have to baby those sometimes. manuals the way to go

 

Not to jack your thread but I'm in the same boat.

I have a 4x4 button and a low range button but niether lights up.

Maybe a blown fuse ?

 

i just need some help, i dont wanna take the truck to the dealer and get charged up the ***.