f150 has dana 44 twin i beam, f250 has dana 60 twin i beam unless it has the solid axle from the factory wich was an option.

 

so its a dana 60 twin i beam?

 

and would a straight axle dana 60 be a direct swap later on down the road?

 

can i tell the difference by looking at the hubs
im not sure if its a dana 50 or 60

 

These are from a 1994, for some reason my auto scource didnt have 89-92 wiring diagrams for that truck. But this should be close.

 

thanks those should help a lot

 

fords came with 40s 60s and 80s no 50s... And its a whole new world to get a straight axle into a twin i beam bracket setup... ID like one in my lfted 94 but its alot of hassle. You may be lucky it could be a heavyduty f250 with solid straight axle!

 

i just went and looked at it and took some measurements
it should raise the front about 6 inches
it should fit perfect also
i also found out that it does have a dana 50 and a 10.25 with 373 gears
the u joints are also the same on both my truck and the 250
http://www2.dana.com/pdf/X510-9.PDF

 

well i got my parts truck today ill get some pics up in the morning
i drove it home and it has some power a lot more then that little 4.6

 

sounds like its gonna be a cool swap. no ford f250 4x4 from 87-96 came with anything but a d-50. dana 60s where only in 4x4 f350s. im excited to see some pics!