2001 no crank after changing flywheel
#1
fxmf4
Thread Starter
2001 no crank after changing flywheel
Hey guys got a 2001 F150 with the 4.6 in it. The flywheel cracked so I changed it out and put the tranny back in. Now it won't crank just clicks any suggestions?
#2
Senior Member
Assuming the battery is known as good, since you just had the starter out, I'd check the connections there.
#3
Senior Member
Yea, check your work for sure. Something forgotten or you got it wrong maybe.
Also, - these connections can be finicky as hell at first. If you didn't clean connections before reconnecting cables/wires, - every one, good chance of getting a bad connect within the system. Hell, I've had that occur with cleaning everything first. If that's the case, loosen, reset the cable/wire and re-tighten. Like I said, they can be picky at the connection.
Multi-meter would come in handy. Connect up top, then connect to starter posts. Simple continuity check may present the bad connection. The cable may have power, but is the starter/solenoid post receiving it ? A cable can look clean but with copper, you can't always see corrosion. They can oxidize making corrosion naked to the eye. Yea, can be THAT picky lol.
Also, - these connections can be finicky as hell at first. If you didn't clean connections before reconnecting cables/wires, - every one, good chance of getting a bad connect within the system. Hell, I've had that occur with cleaning everything first. If that's the case, loosen, reset the cable/wire and re-tighten. Like I said, they can be picky at the connection.
Multi-meter would come in handy. Connect up top, then connect to starter posts. Simple continuity check may present the bad connection. The cable may have power, but is the starter/solenoid post receiving it ? A cable can look clean but with copper, you can't always see corrosion. They can oxidize making corrosion naked to the eye. Yea, can be THAT picky lol.
#4
Torque converter seated fully? Any trouble getting the transmission to bolt up?
#5
Super Moderator
I agree with (97Badass) put a breaker bar and socket on the crank bolt and see if you can turn engine over by hand.... might be bound up on converter.