Last night around 2am i was getting home and in the process of putting my window up i herd like what sounded like a snap and then the window just fell and never went back up.

Does anyone have an idea what that may have been? Now i have a garbage bag for a window.

 

window regulator.

 

I have 3 windows like this right now... I can tell you that a 2x4 cut to the right length and jammed in there right will hold the window up...

It is the regulator and it is a known problem with these... Pull the door panel and you can temp fix it...

 

Pardon my ignorence but does that mean that i have to buy a new motor itself or is that a seprate piece

 

The regulator/motor comes as an assembly. Check out rockauto.com and tascaparts.com for discounted replacements.

 

thanks for the sites atleast i have an idea of what prices im looking at.

how much of a pain in the a** is it do it myself?

 

It's not too bad.

Removal and Installation
Remove the front door trim panel.
Remove the front door watershield.
Secure the front door window glass in the full UPWARD position with tape.
Remove the front door window glass-to-regulator assembly bolts.
Loosen the glass clamp fasteners through the 2 vertical slots in the inner door panel.
To install, tighten to 9 Nm (80 lb-in) .
Disconnect the front door window electrical connector.
Remove the front door window regulator bolts.
To install, tighten to 11 Nm (8 lb-ft) .
Remove the front door window regulator and motor.
To install, reverse the removal procedure.

 

thanks. ill try to get it done as soon as i can

 

Sorry to jack the thread. My front pasenger window goes up extremly slow could that be the motor going out

 

Could be grabbing in the track, look up TSB 07-2-6