Whats needed to change stock exhaust?
#11
2004 FX4 Scab
iTrader: (1)
Originally Posted by backwoodsboy
Single pipe from cats to muffler, then dual from muffler out the back. It's bolt on, and yes I can get you some pictures today!
#12
I used 2.5 but I welded mine in place center to center works fine but I belive I used offset I can't remember now my. 40 series gave my a aggressive tone with minimal drone at 65 at 50-55 you can't even hear it untill I put high flow cats the it got a little more noisy not to crazy but any local muffler shop will weld it in place or next to nothing it's a 30 min job to do a muffler swap
#13
Flowmaster
I just had a Flowmaster 40 series put on my '07 screw yesterday. I had the same concerns about it being too much - it sounds great. Got sound sound bytes-
http://www.youtube.com/watch?v=2Wj4b...ature=youtu.be
http://www.youtube.com/watch?v=-xlVv...ature=youtu.be
http://www.youtube.com/watch?v=HS4FC...ature=youtu.be
http://www.youtube.com/watch?v=2Wj4b...ature=youtu.be
http://www.youtube.com/watch?v=-xlVv...ature=youtu.be
http://www.youtube.com/watch?v=HS4FC...ature=youtu.be
#14
Member
Thread Starter
I used 2.5 but I welded mine in place center to center works fine but I belive I used offset I can't remember now my. 40 series gave my a aggressive tone with minimal drone at 65 at 50-55 you can't even hear it untill I put high flow cats the it got a little more noisy not to crazy but any local muffler shop will weld it in place or next to nothing it's a 30 min job to do a muffler swap
#15
Senior Member
I'll send you a PM, and the drone isn't that bad in my opinion. I'm just changing up the look of the truck, thinking about going with a single pipe with a raptor tip.
#16
2004 FX4 Scab
iTrader: (1)
Originally Posted by backwoodsboy
I'll send you a PM, and the drone isn't that bad in my opinion. I'm just changing up the look of the truck, thinking about going with a single pipe with a raptor tip.
#17
I did an MBRP exhaust system. Thanks for the compliments.
#18
Senior Member
Apologies in advanced to OP, did not mean to hijack thread and turn it into an auction thread ha.
#19
Member
Thread Starter