fx4ski

So I have some KMC XD 20 x 8.5. I bought these used awhile ago off a kid. He didn't know what the offset was.

So the choices are +10, +35, +50.

From what I have read I am assuming I have to get under the truck (not a problem) and measure the mm spacing between the mounting plate and the rim/wheel. Are my assumptions correct?

I was looking for easier options like if it would be labeled on the actual wheel. Anyone's two cents would be appreciated. Gotta go buy a tape measure and figure this ish out.

4nwtf

Look on the back side of the wheel, some wheels have it written/stamped on there. Good luck

kennyf150lariat

I think factory is +35 offset..., I recently put a new set of wheels and tires on my truck.... I went with +18 offset.... I think it is a perfect setup....








Here is some pics, hopefully it helps your decision....

06F150CFCT

Yep...you might have to actually take one wheel off the truck and look on the rim but it should be on there somewhere.

18_F-150_XLT_Screw

iTrader: (1)

Nice site to help you measure: https://www.rsracing.com/tech-wheel.html