PIE Problem
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 6
Likes: 0
From: Central Texas
PIE Problem
I just installed an XM5-FRD04 in my 2007 screw. When I press the AUX button on the radio it goes to AUX, the XM (inno) radio works, then the display reads CRYSTL-LINE for a few seconds before returning to FM. I can press the AUX button a couple of times and get it to DVD, but the XM radio plays for a few seconds before getting "DVD ERROR" and then returning to FM.
Does it have to have constant power, or is hooking it up to the "RUN/ACCESS" on the radio OK?
Any ideas?
Does it have to have constant power, or is hooking it up to the "RUN/ACCESS" on the radio OK?
Any ideas?
08 February TOTM
Joined: Nov 2006
Posts: 3,184
Likes: 29
From: Dumfries, VA Member: #77
Is this what your talking about? http://www.ancoauto.com/oscommerce/p...roducts_id=136
Note: Not compatible if satellite radio, external CD changer, or rear seat entertainment (RSE) are present.
Note: Not compatible if satellite radio, external CD changer, or rear seat entertainment (RSE) are present.
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 6
Likes: 0
From: Central Texas
08 February TOTM
Joined: Nov 2006
Posts: 3,184
Likes: 29
From: Dumfries, VA Member: #77
Looking at the application guide it also says it's not compatible if satellite radio is present. I bet the dvd may also present a problem. You may want to give Tech support a call 800-330-9754
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 6
Likes: 0
From: Central Texas
I spoke with tech support at PIE a little while ago. Apparently there was a change with the '07 radios. What this means is that the XM5-FRD04 requires an upgraded chip. It sounds like this may affect the FRD04-AUX as well. Anyway, they are sending a new chip out today, and said it should take 2-3 days to arrive. I'll keep you posted.